Yes Iāve had 2 but never leaked on my floor the catch pan in my tent caught it all.
Most common is people not setting valves fully in the trays, PUSH HARD!
2nd is silicones get swollen and people donāt recognize it, then they flood this got me once and I noticed it but didnāt clue in. Always have a few spare silicon, good thing is they just need time to dry out.
Pro tip is clip the end of any hose if you remove it, so itās tight the next time you push it on. As the 2nd time you push a hose on a fitting it can have a little leak the odd time so just donāt risk that.
Once you turn the Res on watch it fill, make sure they all fill. Then come back in 10min and feel the bottom of the tray near where the hsoe comes in. If itās wet you have a leak. When you have a leak isolate it one tray at a time until you find it.
The wash is performed after flower and ethanol have been āsoakingā at -40F for 4 hours minimum. Wash being only 5 to 10 minutes, I donāt bother to put back in with the dry ice: I go right to straining ethanol off after the wash is complete.
If you are doing whole plant extraction then a decent freezer is enough. The cold wash process does do a good job of extracting the good stuff to smoke.
@Myfriendis410
It looks a little light
I donāt know if that is a good thing or a bad.
Btw I ran some ok trim nothing special that is for sure.
First time I ran this trim i froze ethanol and trim for 24 hours separate and then mixed together I shook for about 2 min and then placed in a freeze (-16*) for about 5 min and the end result was a little dark so I figured I would let this batch sit for 3 min in -52* F it reads in my cooler with dry ice.
What do you think myfriends?
If all you players and ladies out there have never mixed your beer with a little prepared Clamato you guys and ladies have to try it.
Absolutely delicious