I decided this clone was still short enough to try and train on. Aside from trying to make it fatter and stay low. What else should i do to this little girl.
2 Likes
Hey @TeNNWisKeY your clone looks healthy.
I could take a shot at answering your questions. If you can give the forum more information to better understand your situation. Id bet you’ll get a better answer here.
COPY/PASTE the below list into your forum post.
Answer these simple questions the best you can.
If you do not know, or do not use something; Just say so; Or post
NA (non applicable)
-What strain, Seed bank, or bag seed (photo or auto)
-Age of plant
-Method: Soil w/salt, Organic soil, Hydroponics, Aquaponics, KNF
-Vessels: Type and capacity of container (fabric, plastic, etc)
-PH and TDS of Water, Solution, runoff (if Applicable)
-PPM/TDS or EC of nutrient solution if applicable
-Method used to measure PH and TDS
-Indoor or Outdoor if indoor, size of grow space
-Light system List brand and wattage/spectrum
-Actual wattage draw of lights
-Current Light Schedule
-Temps; Day, Night
-Humidity; Day, Night
-Ventilation system; Yes, No, Size
-AC, Humidifier, De-humidifier,
-Co2; Yes, No
If growing Hydro some additional questions:
-DWC? RDWC? Autopots? Ebb and Flow? Other?
-Distance of liquid below net pot (DWC)
-Temperature of reservoir
-TDS of nutrient solution
-Amount of air to solution
Always try to upload a clear picture in white light of any issues you may have to allow the community to assist you.
What strain, Seed bank, or bag seed (photo or auto)
clone from bag seed (photo)
-Age of plant
6 weeks
-Method: Soil w/salt, Organic soil, Hydroponics, Aquaponics, KNF
mix of organic soil and seed starter soil
-Vessels: Type and capacity of container (fabric, plastic, etc)
fabric 3 gallon pot
-PH and TDS of Water, Solution, runoff (if Applicable)
no runoff yet
-PPM/TDS or EC of nutrient solution if applicable
No nutes given
-Method used to measure PH and TDS
Digital meter
-Indoor or Outdoor if indoor, size of grow space
Indoor roughly 2by 2 space
-Light system List brand and wattage/spectrum
75watt 310 led plant grow light. Its nothing special
-Actual wattage draw of lights
Na
-Current Light Schedule
18/6
-Temps; Day, Night
78/85
-Humidity; Day, Night
56% / 48%
-Ventilation system; Yes, No, Size
Yes 6 inch flitered exhaust fan
-AC, Humidifier, De-humidifier,
Ac at the moment, humidifier not in use. I do not have a dehumidifier
-Co2; Yes, No
No
I tried to answer this to the best of my knowledge, hopefully it will give you enough info to tell me what kind of nutes i should start feeding her and when.
I would not be so inclined to strip its leaves. It also looks hungry.
Do you know if the mother was tall, short bushy etc?
These are two clones that need thinning and pruning before being sent to flower
4 Likes
This clone has always been on the thin side. I was hoping training would help it spread and bush out.
Take that top stretch horizontal. It will make the side branches catch up and even out over time.
1 Like
This what I saw when I first saw the plant
I would then top the 4 remaining branches when the new growth tips are big enough. It looks like you stripped the leaves and growth tips from the inner nodes. Had you left them it would have given you more to work with.
Remove the bottom branches.
It is a type of manifold called a quadline. It is a very productive configuration.
If you do nothing you should move the bottom branches 45 degrees so their growth does not run into the branches above it.
3 Likes
Great advice guys i will definitely keep that in mind moving forward. However it is looking quite spotty today. I may have stressed it out pretty bad already