I just received an HLG 260 rspec kit. This one has the adjustment knob. I believe it’s called a Potentiometer.
I’m looking for a good set of instructions or an assembly video. Any suggestions @dbrn32 ?
1 Like
If you go to the HLG website and select your model of fixture, you will see a link to a Youtube video that shows you everything you need to know in order to assemble it.
It’s actually part one of someone’s product review, but he does a great job assembling both a single-board and dual-board fixture.
And yes, you will strip the wires. He covers that in the video. Also, if you look you will find the proper length to strip is printed on one side of the Wago connector.
4 Likes
Thanks @Dbpooper I found that one with your help. It didn’t address the potentiometer or a few other extra parts. I look at Diablo board tutorial and that covered the rest of it.
I’m going to have to wrap the exposed connections on the potentiometer. but I think This should get me through to tomorrow. Who runs out of electrical tape?? Me.
Tomorrow I’ll zip tie and tape. I think I’ll redo the power cord too.
4 Likes
Sounds good man, wouldn’t hurt to tidy up a bit more so your connections are waterproof essentially and no exposed wires/connections yes. Glad you got it up and running though!
1 Like
You can just trim wires back on power cord, then connector will lock onto outer jacket of cord. The wagos should be fine as long as they’re not stripped to far. Hope you like it!
1 Like