This leaves have been starting to turn bad I don’t know what we is around. 6.5.
I need help! All I know it is a deficiency or something growing in doors strain is super skunk
Need a lot more information. But, almost looks like water burns.
1 Like
Growing with ts1000 I been having this problem every time indoors the temp is always around 19 to 23c in the day and 16c at night. 18/6. About a month old they should be a lot bigger by now. I water a little over 24 hours or more depending if water it is in the early hours I water each plant with about quarter or less full solo cup each. Same problem with is ts 600 in different grow slower growth as well the humidity is 65 or 70% and st night it is 58 or so. Not sure what to do??
Potsmoke check this out…Answer these simple questions the best you can.
If you do not know, or do not use something; Just say so; Or post
NA (non applicable)
What strain, Seed bank, or bag seed
Method: Soil w/salt, Organic soil, Hydroponics, Aquaponics, KNF
Vessels: Pots, Grow beds, Buckets, Troths
PH of Water, Solution, runoff (if Applicable)
PPM/TDS or EC of nutrient solution if applicable
Indoor or Outdoor
Light system
Temps; Day, Night
Humidity; Day, Night
Ventilation system; Yes, No, Size
AC, Humidifier, De-humidifier,
Co2; Yes, No
Always try to upload a clear picture of any issues you may have to allow the community to assist you.
Add anything else you feel would help us give you a most informed answer should be included. Feel free to elaborate, but short and to the point questions and facts will help us help you in a more efficient manner
1 Like
Are you saying you water them every 24 hours, with about a solo cup of water at a time? Try letting the big ones dry out til they droop just a tad, check the pot weight, water them fully til you get a little run off. Then repeat when they get almost to the droop weight/condition again. Fabric pots are what’s up.
Ph? Soil?
Also water the soil not the plant vegetation
Root cause of said issue is?
First of all potsmoke do a flush whid if soil 6.0 and ppm of 250 whid calmag.
Test the run off take it from there ok.
Tough to say until we get more data. We need the information you requested. Right now my guess would be ph. From the photo it looks like only one plant right now, maybe a second just starting.
3 Likes
Nice guess I was thinking ph as well causing what you said earlier. Well done
2 Likes
Hello I you guys think this could be a ph issues? I use a 5 gallon bucket and I ph down till around 6.5 or 6.4. But after a. Couple days the water stinks and I half to dump it out no nuts all I have is ph down in water? The fan leaves are slowly turning as well.
Could ph be to high. Or is the water does not have good circulation could this cause it if so how often should I pump air in to!! Not sure what to do about this issues!
How long are you letting this water sit before using it without air?
Only ph water your going to use right away
To me it seems like you have a drainiage issue your buckets dont have any whole it looks like and holes on bottom with buckets on floor is a recipie for root issues… If the dirt tword the bottom is staying wet with your rate of watering u can be drowing em let em dry out till droop and learn when they droop and try and water just before they do a lil droop never hurt no one but … They must dry out to eat might be food hut take a glass of water and drink a mouthful now try and eat with the water in yoyr mouth…not fun …same thing for the plant
1 Like
3 hours, when going my water can I let it sit or do I just keep plane water in there??
Oh so when I ph I just need to keep water in there and tank like a half gallons as I need it and ph it,
Humidity is 65 to 70%
Temp daytime 20 to24c
Night is 16c
I just started my 5 gallon water storage and ph is around 8 or 9 from a city water I have been ph down may be some of the problem
I put water in it and I ph it but it stays in there for days with air. What do I with it do I ph the water or wait till I need it???
The light is 24 intches from top. I haves fan on it adjustable speed
Ph is more susceptible of drifting numbers when you have higher tds … Plain water holds the number better because theres less substances to effect it. Plain water really isnt to big of a deal to leave UN phed for 3 days but i suggest you let the water breath naturaly then ph your desired dosage when your gonna use it to avoid problems … Also with plain water a lot less ph up or down is needed to get jumps in numbers